Cold start problems S6 AEC

7 posts · 2,350 views · started

#1
Original: German · machine translated
Hello, everybody.

my S6 4.2 has cold start problems – especially now that temperatures are falling, it starts to start worse and worse in the cold.

The bad start in the cold state is expressed as follows:
==References== 5-10 sec. Then he's slowing up or not. With the organ, it always seems as if it is sporadic on one cylinder or another.
==References== He usually starts at the start. It should actually start with a slight speed increase quite full - but it only does not do with warm-starts, however, when cold start. In the first few minutes after the cold start, he only takes very bad gas and sometimes goes out again.

==References== 30 degrees outside temperature it also starts badly at cold start. The curious thing is that when the tank gets empty, the engine starts to start worse and worse – you fill up again – it starts much better again.

For me, this feels like not enough fuel is coming into the cylinders when starting – possibly. The gasoline pressure decreases over a few hours at the stand. ==References== a kind of non-return valve in the petrol circuit that could be defective and the petrol runs back into the tank? I can't find anything in the ACTE.

Target the fuel pump. The error memory is empty!
So far I have exchanged the following parts:

- LLRV replaced several times + cleaned – no change
- LMM exchanged – no change
- Temperature sensor G62 exchanged – no improvement. Have also measured the values and also those of the intake air temperature generator but the corresponding specifications from the RLF
- Fuel filter replaced – no change
- Distributors and caps before approx. Renewed 20tkm
- spark plugs NGK BUR6EFSZ

- Compression on all cylinders at approx. 13bar
- ZR before approx. 25tkm changed at Carsten in the forge – should therefore fit everything

Maybe. someone already had a similar problem or other tips?

Is there an experienced screwdriver in the NRW/Düsseldorf region that can solve the problem?

Thank you very much

Welcome
Jörg

Edited by Jörg

WhatsApp
#3
Hallo Roy,

genau an dieses Teil habe ich auch schon gedacht - nur ist laut AKTE dieses Teil beim AEC (HG2, UG01, Bildtafel 201-90) nicht verbaut.

Gruß
Jörg
WhatsApp
#6
hi,
meiner springt je nach sprit besser oder schlechter an. also bei super+ gut und bei super nicht ganz so gut.

in deinem fall versuch mal die zündung für 10 sekunden anzumachen, dann wieder aus. dann machst du einen startversuch. es wäre ja möglich dass deine benzinpumpe verschlissen ist und kaum benzindruck aufbaut.
WhatsApp
#7
Hallo,
ja an die Benzinpumpe habe ich auch schon gedacht - allerdings läuft die Pumpe nicht an wenn man nur den Zündschlüssel auf Zündung ein stehen hat sondern erst wenn der Anlasser eine bestimmte Umdrehungszahl bringt. Von daher müsste man irgendwie das Relais für die Benzinpumpe brücken - weiss vielleicht jemand welche Kontakte gebrückt werden müssen? Das Relais habe ich schon gefunden auf Steckplatz 6 unter dem Fahrer-Ablagefach.
Danke!
WhatsApp

Join the conversation, see photos and ask questions? Sign in with your forum account.

Sign in