I started resealing an increased steering gear and found a very good guide in the forum
. However, this is probably the normal power steering, which did not bother further until the last step (extension of the steering spindle) 
.Here you should loosen 2 screws, pull out the spindle with the upper part of the steering gear box and then squeeze the spindle out of the top.
But with me, the spindle remained in the steering gear box when the top was removed, which is perhaps also supposed to be the case with the Servotronic, only: How can I get it out there?
??If I want to change the 5 sliding rings on the spindle, I have to disassemble them further, because the rings are not made of rubber. Or do I see it wrong? Has anyone ever done this before and can give me tips?
Greeting Carsten