I need your help again!
My V8 has recently carried out a number of work:
- rear brake discs and pads have been changed
- both brake ropes renewed
- rear triangle handlebar bearings exchanged
- Petrol filter renewed
- Brake pads new at the front
Furthermore, the fuel tank had to be changed because the old tank was rusted and licked. To do this, almost everything had to be dismantled in the rear area (from the cat's) below the vehicle. It's a mortz job!
After everything is installed again, the indicator light for the Servotronic is now constantly lit.
My screwdriver says that this cannot be related to the repair; in the case of the o.a. There would have been no interference with the Servotronic system.
I have to note that the rear of the vehicle was up about 3 weeks due to the extensive repair. The front wheels were on the ground.
It may be that the angled position caused a defect in the servotronics. the control light was triggered?!
Or what else could it be?!
Before the repair, the indicator lamp definitely did not glow!
Does any of you have an idea?!
Greetings from the North Sea!
Henry
