So now I'm almost 20min. the board has searched for brake wear sensor or similar and not found I now have to write myself.
I changed the brake discs and the pads at the front of my baby today - of course with new wear sensors - but the board computer still complains that the pads are worn out.
Then I checked the connections of the sensors - all right!
Followed the line - all right!
Does our baby have a plug or a fuse somewhere else I have to look - because I don't know now where to look anymore.
We didn't have any sensors in the back, so I changed the badges and coverings last week.
I already had the check run 3 times, whereby he says "OK" at the end of the check, but what I don't understand is that he immediately brings the display over the coverings again.
Brake fluid is enough (perhaps a little too much),the pads around are new.
Does anyone have any idea what that could be... I don't remember...
