...then it might. are that the holding clips of the board have broken out!
So also with me, see picture. This then leads to the fact that there is no clever contact between the board and the press buttons, because the whole board is always pushed backwards.
The best way to do this is to expand the entire climate. The control panel with the buttons is attached with three screws. Screw these, then the control panel can be removed at the front. I then glued a few strips of self-adhesive foam between the control panel and the housing, which is about 5mm thick. Now, when you screw the control panel back on to the housing, the board is pushed forward through the visor and a clever contact between the push buttons and the board is now being created again, as it no longer evades the back.
Greetings Luke
Edited by Lukas
