Webasto heater retrofitting

8 Beiträge · 9.398 Aufrufe · gestartet

#1
I have purchased a used Webasto heater for my '92 V8 4,2. It comes from a V8, but unfortunately the hoses and fittings for the coolant circuit are not complete. I am therefore not sure exactly where to connect the hoses. I have the one-way valve, that is attached to the heat exchanger for the defroster, and the thermostatic valve at the heater is also there. As far as I can see in the coolant circuit diagram, there is supposed to be a T-piece somewhere, but I don't know where. A picture would be very helpful, or a description of where the hoses belong.

Best regards

Jesper Nathan
WhatsApp
#2
Hello,

do you need the repair documentation? There is a quite good description (unfortunately in german only). If it´s ok for you I´ll send it via e-mail.

By the way: you need a 2-way valve if you have a V8 with climate control. The T-connector should be placed between motor, themostate and the backflow-preventer-valve.
WhatsApp
#3
Hej Jesper

Hvis du melder dig ind i Audi klubben i Danmark
er der fler der kan hjælpe dig.
WhatsApp
#4
>Berthold,
thanks for your reply. I already have the repair documentation. I have ordered the missing parts for the coolant system, so I think I will figure it out.

>Jan,
jeg har overvejet at melde mig ind i audi-club.dk igen, har været medlem engang. Hvis der er andre, som også kører V8, kunne det være interessant.
WhatsApp
#6
hej jeg hedder jens chr og kommer fra himmerland, jeg har en v8 fra 88 der er ombygget til en 93. kunne være dejligt at møde nogen andre med en v8 i audiklubben
WhatsApp

Mitreden, Fotos sehen und Fragen stellen? Melde dich mit deinem Forum-Zugang an.

Anmelden