from my negative experience with the engine power of my S6 I have been browsing the Internet a little bit, and I have been looking for software that can create performance diagrams from the VAG COM data (log files) (to save the future performance measurements on the test bench until the error is found).
And look at this:
EasyDiag Freeware
This software can be used from:
Speed
Speed
Timeline
Weight of vehicle
Temperature (for DIN-PS calculation)
Air pressure (for DIN-PS calculation)
Create a performance chart:
X-axis with speed
Y-axis with curve 1 = torque
Y-axis with curve 2 = power in PS.
You have to do the following as a test ride with VAG-COM-Logging:
At about 1500 rpm in the third gear on the BAB, drive up to the speed limit below full load, then out gear shortly before speed limit and let the wagons roll out until the initial speed at about 1500 rpm.
This roll-out process is necessary for recording the loss rates (gear, tyre resistance, air resistance) and can thus correct the deceleration values, so that the pure engine power is excluded.
I think I'm great! My weekend is secured, I'll post the result here.
Page
Openobd OBD page
is also very helpful when looking for labels.
Greetings
Martin
P.S. So the physics lesson of kinematics is really fun, especially so practical!
