Vorheriges Thema
Nächstes Thema
Thema drucken
Thema bewerten
Registriert seit: Jan 2005
Beiträge: 19
stranger
OP Offline
stranger
Registriert seit: Jan 2005
Beiträge: 19
Does anybody know where are locating Ignition sensor and RPM sensor on Audi V8 3.6l PT engine… Can you send me some picture, easier to locate?
I have some picture where RPM sensor and Ignition sensor are locate above O2 sensor, but I look on my care and I find only O2 sensor…My V8 is 1991...

Registriert seit: Mar 2006
Beiträge: 2
stranger
Offline
stranger
Registriert seit: Mar 2006
Beiträge: 2
Hello,

those sensors youre looking for can be found behind the excaust behind the heatshield, at the drivers side of the car.
you can find these by following the wiring wich can be found under the ignition

Registriert seit: May 2004
Beiträge: 44
newbie
Offline
newbie
Registriert seit: May 2004
Beiträge: 44
I think it's what you want.
and you can see the "pression thing" for the cruise control

100710-piece11.jpg (0 Bytes, 330 downloads)
Registriert seit: Jan 2005
Beiträge: 19
stranger
OP Offline
stranger
Registriert seit: Jan 2005
Beiträge: 19
Thank You...
In meantime I find error that bother me, but because I don't speak German I didn't find solution yet. It's some error Hakkgeber - G40 and Geber fur Motordrehzahl - G28 (some sensors I supose)

Registriert seit: May 2004
Beiträge: 44
newbie
Offline
newbie
Registriert seit: May 2004
Beiträge: 44
yes, both are sensors,
one for the Hall detector (g40) and the other is the rpm sensor (g28)

sorry can't give you further help , i do not have the audi parts number

Registriert seit: Oct 2004
Beiträge: 2,601
Carpal Tunnel
Offline
Carpal Tunnel
Registriert seit: Oct 2004
Beiträge: 2,601
Hi Vladimir,
have a look at this link .
It shows the way to change G28 and his brother ( i don't know his name ).
The number of this part is listed in this link. Both sensors are working the same way, only the colour is different.
Maybe it helps...


In diesem Sinne Gruß Bernd
Registriert seit: May 2006
Beiträge: 4
stranger
Offline
stranger
Registriert seit: May 2006
Beiträge: 4
Hello..
The sensors is located on the left side of the engine under the exauste.
If you go under the car you should se the sensors whitouth any problem. (I´ts more difficult to remove them :P)

104441-Sensors.jpg (0 Bytes, 280 downloads)
Zuletzt bearbeitet von Edwin Andersson; 17.05.2006 10:50.

Audi V8 3.6L -91 Audi 90 2.3L 20V -90 Audi 90 2.2L -86
Registriert seit: Apr 2004
Beiträge: 191
member
Offline
member
Registriert seit: Apr 2004
Beiträge: 191
Hi there!

As far al Hallgeber (correct german spelling) is concerned, that one is not located under the engine - it is integral part (no separate spare part available) of steerboard distributor. Once I had Hallgeber-failure, resulting in 4 litres/100 km excess fuel consuption with same time about 100 hp missing. It was in fact a problem with Hallgeber wire insulation, underneath the distributor, which was caused by animal biting. New piece of wire and ABH is back to performance.

So, have a look at wires leaving distributor, maybe going to/coming from the sensors you were shown by other members.

Andreas


Es war schon immer etwas teurer, einen besonderen Geschmack zu haben...

Moderiert von  Manfred H., Manfred M., Thorsten D 

Link in Zwischenablage kopiert
Powered by UBB.threads™ PHP Forum Software 7.7.5
(Release build 20201025)
Responsive Width:

PHP: 7.4.28 Page Time: 0.042s Queries: 33 (0.038s) Memory: 0.6152 MB (Peak: 0.7064 MB) Data Comp: Off Server Time: 2024-05-21 23:25:30 UTC
Valid HTML 5 and Valid CSS