I recently changed the timing belt on my 91 Audi V8 with a 4.2 from a 93.
The first time, i got the timing one tooth off, and it ran very poorly, if at all.
Anyway, i purchased all the needed tools, the cam locks and everything, and set it correctly this time.
However, it wont start.
Last week i purchased a Ross Tech diagnostics unit to hook up to my laptop.
Here are the five fault codes it gave me for the engine.
Sunday,06,February,2011,21:16:47:38869
VCDS Version: Release 10.6.3
Data version: 20101206
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
Address 01: Engine Labels: None
Control Module Part Number: 441 907 557 DA
Component and/or Version: MOTOR D01PMC 4
Software Coding: 0261203011
Work Shop Code: 1267357228
VCID: 5FC7A5A1F7BB
5 Faults Found:
00525 - Oxygen (Lambda) Sensor (G39)
03-10 - No Signal - Intermittent
00281 - Vehicle Speed Sensor (G68)
03-00 - No Signal
00515 - Camshaft Position (Hall) Sensor (G40)
30-10 - Open or Short to Plus - Intermittent
00513 - Engine Speed Sensor (G28)
03-00 - No Signal
00516 - Closed Throttle (Idle) Position Switch (F60)
30-00 - Open or Short to Plus
Readiness: N/A
Sunday,06,February,2011,21:21:01:38869
VCDS Version: Release 10.6.3
Data version: 20101206
I have ordered a camshaft positions sensor from my mechanic, and am waiting for it to come in.
I have also read that the Throttle position switch may need to be cleaned, i will post the link later.
Any ideas what to do?
It turns over and everything, and sometimes it almost starts, but doesn't. I can post a video tonight or tomorrow.
