|
|
Registriert seit: Apr 2010
Beiträge: 2
stranger
|
|
stranger
Registriert seit: Apr 2010
Beiträge: 2 |
Hello van anybody help me my clutch pedal (manuel gearbox) stays on the floor and won't come up anymore !!! So now I can't drive the car anymore.
It's a 4.2 V8 quatro
Zuletzt bearbeitet von steve B; 25.04.2010 03:50.
|
|
|
|
|
Registriert seit: Aug 2002
Beiträge: 13,286 Likes: 2
Carpal \'Tunnel
|
|
Carpal \'Tunnel
Registriert seit: Aug 2002
Beiträge: 13,286 Likes: 2 |
Hej Steve,
check your master/slave zylinders of the clutch.
Bastian
|
|
|
|
|
Registriert seit: Apr 2010
Beiträge: 2
stranger
|
|
stranger
Registriert seit: Apr 2010
Beiträge: 2 |
thank you for your reply, if the master slave zylinder is broken ( I think it is ) is this easy to repair ! I have seen them on ebay for about 150 euro for both, so that is o.k.
steve
|
|
|
|
|
Registriert seit: Aug 2002
Beiträge: 13,286 Likes: 2
Carpal \'Tunnel
|
|
Carpal \'Tunnel
Registriert seit: Aug 2002
Beiträge: 13,286 Likes: 2 |
Hi,
there are two cylinders: The master, and the slave cylinder. The first one is up at your pedal, the other one is down at the clutch. One of both could be broken - the symptom fits.
But as important as a new cylinder is the correct venting of the clutch afterwards. That may require your Audi dealer as he has the required venting machine. Manual venting often causes troubles!
Bastian
|
|
|
|
|
Registriert seit: Aug 2003
Beiträge: 2,009 Likes: 3
Pooh-Bah
|
|
Pooh-Bah
Registriert seit: Aug 2003
Beiträge: 2,009 Likes: 3 |
Hi Steve, it is recommended to change master and slave cylinder simultaneously. And as Bastian said: Bleeding procedure has to be executed carefully. And last but not least: The pair of cylinders is available much cheaper than 150€.
Beste Grüße Tim
|
|
|
|
|
Registriert seit: Aug 2002
Beiträge: 13,286 Likes: 2
Carpal \'Tunnel
|
|
Carpal \'Tunnel
Registriert seit: Aug 2002
Beiträge: 13,286 Likes: 2 |
Hi,
I strongly suggest to stay with Audi original parts here. You probably remember my breakdown due to a reproducted, cheaper master cylinder back in 2008. It lasted for not more than 60tkm before it was broken again.
Bastian
|
|
|
|
|
Registriert seit: Aug 2003
Beiträge: 2,009 Likes: 3
Pooh-Bah
|
|
Pooh-Bah
Registriert seit: Aug 2003
Beiträge: 2,009 Likes: 3 |
Hi Bastian, (how funny, to communicate in English), of course, I remember. But there are quite a lot of differences between the quality of suppliers respectively their parts. I know some very confident part dealers. They deliver high quality spare parts for favourable prices. These parts are quite cheap but not jerry-built. But [censored] happens, and the sudden end of your clutch cylinder might simply also have been bad luck. There are repair-kits for cylinders available as well. This is the cheapest and very often a successful solution.
Beste Grüße Tim
|
|
|
Link in Zwischenablage kopiert